- Position:
- Batte Melt pump > NEWS >
2014-03-21 Melt pump should be the most basic conditions
Melt pump should be the most basic conditions: ● light weight, low consumption of metallic materials; ● Compact, small footprint, small footprint; ● save energy, water and hydraulic energy; ● Simple structure, small number of parts,
2014-03-19 The new kind of performance extrusion melt pump system
And using the pressurized melt pump it with the measured characteristics of a single-screw extruder series combination, which can form a melt pump extrusion performance of the new system. The basic idea of ??constructing this extrusion syst
2014-03-19 Zhengzhou Batte, steady flow of the melt pump working principle
Melt pump , resistance occurs when the outlet of the pump, such as the filter, or a filter plate mold produced, the pump cylinder barrel gear like a piston, the embodiment of the discharge zone the melt extrusion role in order to achieve th
2014-03-19 Batte melt pump installation and use
Zhengzhou BATTE melt pump offers three installation methods : a drive shaft mounted horizontally , the drive shaft is installed facing up , install the drive shaft down , depending on the location and convenience of the site to select the i
2014-03-18 The main features of Bart melt pump
1 . The extrusion products to minimize dimensional tolerances , material per unit weight of the system out more products. In extrusion products require strict dimensional tolerances or products more expensive raw material costs , the use of
2014-03-17 Batte: melt gear pump can not be ignored
Batte: melt gear pump can not be ignored On-board sheet, pipe , biaxially oriented film , fiber optic cable and other products produced in the extrusion process , a melt gear pump mounted on the extrusion equipment is necessary . What melt
2014-03-17 Company dedicated to promote the new rubber melt pump
Stability rubber for melt pump has a crucial impact on the quality of the extruded product. In a single screw extruder, a melt pump for rubber to various forces in the screw speed fluctuations can vary, but also greatly reduces the increase
2014-03-15 Melt extrusion pump to increase production
Extrusion output increases , generally when the pressure within the extruder is increased , the amount of counter-current flow increases and the drain , causing the entire flow rate. While advancing the screw drive material consumed power i
2014-03-15 Melt pump can improve the quality of products, reduce material waste
improve the quality of products in the absence of melt gear pump extruder screw conveyor taste due to the instability of the material is not sufficient, the material in the melting or softening point of unstable solid bed broken, do not feed
2014-03-14 Precautions melt pump
Avoid low interference In the extrusion process, the plastic material concerned, from a solid to a molten state should have sufficient soak time . If the extruder before the start of production has not yet reached operating temperature , th
