- Position:
- Batte Melt pump > NEWS >
2014-03-19 Batte melt pump installation and use
Zhengzhou BATTE melt pump offers three installation methods : a drive shaft mounted horizontally , the drive shaft is installed facing up , install the drive shaft down , depending on the location and convenience of the site to select the i
2014-03-18 The main features of Bart melt pump
1 . The extrusion products to minimize dimensional tolerances , material per unit weight of the system out more products. In extrusion products require strict dimensional tolerances or products more expensive raw material costs , the use of
2014-03-17 Batte: melt gear pump can not be ignored
Batte: melt gear pump can not be ignored On-board sheet, pipe , biaxially oriented film , fiber optic cable and other products produced in the extrusion process , a melt gear pump mounted on the extrusion equipment is necessary . What melt
2014-03-17 Company dedicated to promote the new rubber melt pump
Stability rubber for melt pump has a crucial impact on the quality of the extruded product. In a single screw extruder, a melt pump for rubber to various forces in the screw speed fluctuations can vary, but also greatly reduces the increase
2014-03-15 Melt extrusion pump to increase production
Extrusion output increases , generally when the pressure within the extruder is increased , the amount of counter-current flow increases and the drain , causing the entire flow rate. While advancing the screw drive material consumed power i
2014-03-15 Melt pump can improve the quality of products, reduce material waste
improve the quality of products in the absence of melt gear pump extruder screw conveyor taste due to the instability of the material is not sufficient, the material in the melting or softening point of unstable solid bed broken, do not feed
2014-03-14 Precautions melt pump
Avoid low interference In the extrusion process, the plastic material concerned, from a solid to a molten state should have sufficient soak time . If the extruder before the start of production has not yet reached operating temperature , th
2014-03-14 Melt pump of installed correctly
Damage usually melt pressure sensors are not appropriate due to its mounting position caused . If the force sensor is mounted in the hole is too small or irregularly shaped holes in the film is likely to cause vibration and impact damage to
2014-03-14 Melt pressure sensor in the installation and maintenance of plastic machinery
In the extrusion production line , high-temperature melt pressure sensor to improve melt quality, improve production safety and protection equipment and other aspects play an important role. Meanwhile, melt pressure sensor is very sensitive
2014-03-13 Comparison of high temperature and high viscosity gear oil pump
High temperature gear pump is a polyester melt conveying , pressurization and melt metering essential equipment. Than other types of heat pump melt pump , compact structure, reliable operation, low energy consumption, high volumetric effici
